2 Attachment(s)
a little Line Lok modification...
Working on mine as well. Using the MINI Line Lok and Lawsons Glowire. I am going to use 1/8" Shock Cord, with what I did here, it now fits. I picked up the 1/8" stuff at REI also. Will test and see how all does with the Kelty Noah's Tarps 12' x 12' & 16' x 16'.
What I Did:
MINI Line Lok: the hole where (initially the 3/32) Shock Cord would go parallel to the 3/32 (2.38mm) Glowire was a little tight. The thin lip seemed to cause some rough drag when pulling cord through. I pulled out my Dremel with a small Diamond Wheel Point and removed that lip. I don't feel that the lip is needed with the (Shane) application. I did not enlarge the hole, because that may weaken the Line Lok! I used the Diamond bit to also gently debur. I held the Line Lok in a small set of Vice Grips with a mild grip. I did (16) pieces in approx. 15 min. running the Dremel near the lowest speed (2nd notch).
Note: Fits 1/8" Shock Cord & 3/32 (2.38mm) Cord now
Just thought i'd share...