using pe foam glued together i made a pad thats 23" x 60" x 1/2" going to test it out next weekend weather man says low is 45. This pad is much more flexable then a blue pad and I figure should give as good or better results and it only weighs 9 oz.
Printable View
using pe foam glued together i made a pad thats 23" x 60" x 1/2" going to test it out next weekend weather man says low is 45. This pad is much more flexable then a blue pad and I figure should give as good or better results and it only weighs 9 oz.
How small can you get it rolled down to? You should be sweating with that thick of a pad at 45 degrees. I like the idea, though. Let us know how it goes for ya!
have it rolled up to 11 1/2" tall and 8"diameter roll
Wow, not bad at all! Nice job!
I'll be interested to see how this works as well. Sounds like it packs pretty small for a pad. Nice.
If it works, you should post a DIY thread!
I definitely want to hear more about this!
The rolled size is impressive, what kind of glue did you use? Sounds like a great idea.
3m general trim adhesive its made for like headliners in cars.
ok here is my report pad preformed great with some exceptions it needed to be wider as my shoulders got chilled and a little longer would have been nice as my head wasnt on it. the low was 42 so not bad for 9 oz. next test will be with a bigger one. I think somewhere in the 46 by 72 range. i think it could have been a bit thinner and been fine might try 1/4 in this time.