suggestions??
Bill
Printable View
suggestions??
Bill
They will all work, none worse than others, all of them better.
after looking at all of them I beleive your correct.
Thanks as I have selected one
Bill
Quote:
Originally Posted by DemostiX
So which one did you select?
I use a JRB Greylock (I think it's a 3) with my Clark Tropical hammock. The corner tabs on the JRB quilts line up nicely with the Clark's tabs on their hammocks. Four mini-biners connect them nicely without too much weight.
I've also used the four tabs on one Clark or another with one quilt or another. Because there is such a substantial seam to which to attach a new pair (or quartet) of tabs with no danger whatsoever to the integrity of the hammock from that stitching, I would encourage you to think of adding a pair in the seam of hammock bed and foot-end hood. Then, there's no dependence on the coincidence of tab span and UQ length.Quote:
Originally Posted by bear bag hanger
That's no criticism of the JRB Greylock. It's a suggestion from someone with too many hammocks and too many quilts!! Ten minutes per hammock with a needle, thread, and a short strap, gros grain, folded-over fabric strip, or shock-cord and cord-lock, and you're ready for any UQ.
Bought a flex 180 so will need to have a quilt made.for it
thaks for all your help
Bill
In single person mode, any UQ will work. In 2 person mode, I would expect 2 UQs would work, just as they do for the Vertex, as each bed could be covered independantly.Quote:
Originally Posted by eightweight
A "naive" ultra-wide UQ for the vertex/flex would not work as well, as the gap between bodies would it impossible to get the UQ tight against the inside of each of the two bodies. That may or may not be a problem as ultimately on the other side of that uninsulated area is another body seperated by air, but you would be trying to heat a bunch of additional dead space and spreading out your body heat that much further.
A highly customized UQ could be concieved of, but it would be very expensive as it would require lots of shaping darts etc, and likely additional suspension to keep it tight in the middle to avoid the "naive" problem above. Also, it would probably only tend to work at a given width of "flex spread", so you would have to be very consistent in which trees you select.
The complex version is in effect just 2 seperate UQs, with some connecting fabric (and wasted insulation where nobody is sleeping)
All in all 2 seperate gives you the flexibility to use the hammock in single or flex mode, and also gives you compatability across to other hammock models, which is important for resale value.
I thank you for the suggestion as I will be using it in single person mode and have no current plans to use it for 2 but really like the space.
Underground makes the zepplin and I did check to see if they could make it bigger and they can for a very reasonable price .
the other is to just get a 20 degree incubator with extra down and be done as you can move that one all over the hammock.
I agree and thank you for the comment that the single would also work for my application
Bill
QUOTE=gaijin42;779713]In single person mode, any UQ will work. In 2 person mode, I would expect 2 UQs would work, just as they do for the Vertex, as each bed could be covered independantly.
A "naive" ultra-wide UQ for the vertex/flex would not work as well, as the gap between bodies would it impossible to get the UQ tight against the inside of each of the two bodies. That may or may not be a problem as ultimately on the other side of that uninsulated area is another body seperated by air, but you would be trying to heat a bunch of additional dead space and spreading out your body heat that much further.
A highly customized UQ could be concieved of, but it would be very expensive as it would require lots of shaping darts etc, and likely additional suspension to keep it tight in the middle to avoid the "naive" problem above. Also, it would probably only tend to work at a given width of "flex spread", so you would have to be very consistent in which trees you select.
The complex version is in effect just 2 seperate UQs, with some connecting fabric (and wasted insulation where nobody is sleeping)
All in all 2 seperate gives you the flexibility to use the hammock in single or flex mode, and also gives you compatability across to other hammock models, which is important for resale value.[/QUOTE]