the Plucked Chicken- DIY Tyvek Hammock/Suspension Stuff Sack
...or, at least that's what my wife and girls call it.
Two large mailers and Tyvek tape were used to create a "No-Sew" tubular style stuff sack with three compartments, each individually closable with cinch cords. Hammock gets stuffed in the middle compartment and the suspensions from each end in each end compartment.
All pics in this post were taken using the Plucked Chicken with my HH Hyperlite Backpacker with ZQ2Q mod2, additional gear loft on ridgeline, peak bag installed in one end, DIY AmSteel UCR suspension and HH 1" straps. This same bag was used this last winter season with HH supershelter (bottom and overcover) installed, but since removed to to warmer weather:
Attachment 24942 Attachment 24945 Attachment 24943 Attachment 24944 Attachment 24947
For deployment, just:
(1) pull straps from one end:
(3) pull other end, wrap/attach:
(5) loosen one end of center compartment, and tighten my AmSteel UCR's.
(2) large tyvek mailers
Tyvek tape cut to 1/2" strips
(4) 18" lengths of cinch cord (I used gutted paracord)
(4) cord locks
Quick and dirty how to:
(1) Cut the top closure from both packets. Stick them in the washer for a cycle to soften, then air dry them outside.
(2) Slit the bottom of the first mailer, then added cinch cords to each end making the center compartment for the tube.
(3) Cut the second mailer into two half length tubes, then taped the bottom edge of each to the circumference of each end and cinch corded the top ends again.