I have gone through the thread for the DIY – Hennessy Hammock (and some others)and see multiple references to making this a double layer, even a triple layer for a "hanger of size". How exactly does it come together?

- Do I just hem two separate layers and whip them at the ends?
- Do I sew the 2 layers together on 3 sides, leaving the entry side open to slide the pad between? (This is the way I see it in my head, but will the layer still slide independent of each other and not bunch and bind?)
- If I use the tunnel method on the ends, do I sew both layers together for just the 8" on each end?
- How about tie outs both layers, or just the outside layer?
- Speaking of tie outs... If I add the triangles to decrease the turn of the zipper, do I add the triangles to both layers, or just the outside?

Like most adults, I am a very visual and tactile learner. I have always been challenged by story problems. So after reading some of the explanations, it just confuses and frustrates me more and more.

For example when I start thinking about integrating a bug net, in the HH-Sticky I ran across this from DownUnderHang

Seriously?!?!?! :eek: DownUnderHang you have a brilliant mind, but we are on 2 different pages? I’m still at the begining where the Pop-Up pictures are. There has got to be an easier way...Quote:

I've based it on H4U's original diagram and added some more dimensions. A, B and C are as per the original diagram. As you can see the pattern has been rotated on the material to be cut. NB: This does mean that the ridge line does not follow the weave of the material but this wasn't a big deal for me.

The key measurements we are after is G - the width to be cut, H - the off-cut length, and, if you don't want to use the ridgeline measurement on the angle, the length of the material (not given a letter in my diagram). To get these measurements, we first need to calculate some other measurements - D, E and F as follows:

D = Square root of (C squared - B squared)

E = A - D

F = Square root of (E squared + B squared)

Now we can get G = B/F*A

And H = Square root of (C squared - G squared)

The length of the material to be cut from is F+H

So to cut the material measure off a length of F+H, cut it to a width of G. Then measure down H from the top right corner and cut from there to the top left corner in a straight line. Then measure up H from the bottom left corner and cut from there to the bottom right corner in a straight line.

I hope that helps - it worked for me.

Other examples use a piece of plastic or Tyvek to lay over the ridgeline. The edges are pinned together to get the shape. Cut out, add zippers, and voila! Is this the simplistic approach I am looking for? Anyone else have suggestions that worked for them? Perhaps I am just making this more complicated than it needs to be.

I have combed thought the 43 pages in the DIY-HH sticky and a few others. All the comments, ideas, and discussions that has spanned over the last 5+ years are wonderful. I have learned a lot. It has been interesting to read all of the personal touches people have integrated into their designs. This is what draw me to DIY in the first place. So please don’t take my frustration and inability to visualize these concepts here as derogatory. Just trying to find a little humor as I continue to try and fill the gaps…

Thanks for any direction you can provide...