Search:

Type: Posts; User: Dutch

Search: Search took 0.19 seconds.

  1. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    I think you will probably own the only one. But...

    I think you will probably own the only one. But that makes it even cooler.;)
  2. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    NCP-It looked so much like a whistle that I had...

    NCP-It looked so much like a whistle that I had to try it. Apparently there is more that goes into a whistle than just an angled slot. Like me with piano it couldn't play a note.

    I never...
  3. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    WV sent me a mountainfitter stake and it works...

    WV sent me a mountainfitter stake and it works better than I thought. The looped end fits into the end of the boom. I will mail this out to you tomorrow.
    23483
  4. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    Made the boom last night. It looks like a very...

    Made the boom last night. It looks like a very strong whistle. You can't see it but there is a 1/8th hole through the one end. The only problem I see is with the cord tied though the tube like...
  5. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    To put an angled hole in round ti with a drill...

    To put an angled hole in round ti with a drill bit would take a much better machinist than I. So I am going to try to grind angled slots with the surface grinder. I may first grind and then finish...
  6. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    The holes might be more like slots because it is...

    The holes might be more like slots because it is real hard to drill on round TI. In any case it will be 2 holes on one side that go at about a 45 degree angle and a hole on the other side. I'll try...
  7. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    I didn't misunderstand i was eager to help as it...

    I didn't misunderstand i was eager to help as it looked like a neat idea. I have a piece of ti tubing that would fit the bill if you would like me to fashion something.
  8. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    I really didn't see the negativity in anyones...

    I really didn't see the negativity in anyones post. Nothing was disparaging to you that I could see.
  9. Thread: Stake Boom

    by Dutch
    Replies
    119
    Views
    44,922

    So what you want is a ti tube with a hole drilled...

    So what you want is a ti tube with a hole drilled in it and notch on the other side with a ti stake that fits inside.
Results 1 to 9 of 9