MARPAT Tarp with doors

[Snowball]

I decided to sew the perimeter. Did not look like it would hold without.
I used an embroidery ring to hold the fabric flat and to prevent wrinkles in the seam.
I will seam seal in the near future.
IMG_20160417_183858.jpg IMG_20160417_183936.jpg IMG_20160417_192908.jpg

[Caminante]

Innovative use of the embroidery ring - I'll have to put that in my toolbox.

[Snowball]

Innovative use of the embroidery ring - I'll have to put that in my toolbox.

If you have to buy one, choose a low model. I have to remove the presser foot + do some manually lifting to get enough clearance. It’s not a problem but annoying.
IMG_20160418_155229.jpg IMG_20160418_155342.jpg

[Spark]

Nice tarp! BTW the double 1/2" Beastee D on the ridge have worked fine for me.

[Caminante]

If you have to buy one, choose a low model. I have to remove the presser foot + do some manually lifting to get enough clearance.

Good point. I just went through a huge struggle trying to sew through 3d mesh, 3/8" foam, and fabric.