I am still in the planning stages for my first DIY UQ. It has been a long summer of chores and I am finally getting some time to spend working on this.
One thing that I have noticed while looking at others UQ designs is that the baffle material (my case nanoseeum) doesn't go to the end of the quilt. It stops an inch or so short of the ends.
I guess my original thought would have been to totally close off each baffle by going to the end and then sewing each baffle closed while finishing the ends.
I could see that the material could get bunched when closing the ends up.
I just wanted to get this settled, before I start sewing.
Thanks in advance.
Shevy77
Bookmarks