Mamajamba door help

[ulyssesjones]

I am trying to set up my Mamajamba for the first time. I can not figure out the removable doors. On one edge of the door there are three attachment points. I understand the two corners but can not figure out where to attach the middle point with the shock cord. Does any one have a picture or a good talk through? I know once I see it it will be obvious. The video on the warbonnet web site shows doors with snaps down the edge. The doors I have do not have the snaps.

Thanks

[silentorpheus]

Here's a link to Shug's video review of the Mamajamba he got recently. I think he goes over how to attach the doors.

[^shane^]

Here's a couple of shots to give you an idea.

Keep in mind... The first two shots are of my BMJ doors on an OES Deluxe tarp. It works. Not quite as good as on my BMJ, but it works.

Tarp with one set of doors attached:


Two sets of doors on my BMJ


If I'm only putting doors on one side, I run the shock cord to the o-rings on the other end of the tarp ridge. If I'm putting on both sets of doors, I run the shock cord from one door to the shock cord on the other door and connect them using the mitten hooks.

[ulyssesjones]

Thanks. That is what I was guessing but wasn't sure.

[Bat]

I find when I put the doors on mine if I go to an over the tarp ridge line it seals up better. That isn't my normal set-up so I hope my experience saves you from some fiddle time.

[warbonnetguy]

ther should have been some directions, sorry if i forgot.

the grey corner tab goes to on the bottom, the shockcord flap can be attached to the opposite ridge line attachment point or to the shockcord of an opposing door, (or to the panel pulls, but i like the other 2 options better)