Cleaning up my stove box. I went a little overboard making alcohol stoves. All of these are "test" stoves, so they have been used in my kitchen.
The bud light bottle stoves (A-D) are normal alum beer bottle stoves with the neck inverted into the base, similar to the whitebox and many other designs. Rolled rims instead of epoxy or rivets. About 2.5" tall. Jets vary in number and height, but most around 5/8"-3/4" from top. These will fit under a heine pot with no pot support, but are more efficient with a wider pot.
Similar performance on all the stoves. None of these stoves are vented back to the center. More jets boil a little faster but don't run as long. All will boil 2c tap water on 1oz alcohol in a GSI soloist pot with no windscreen. All prime in about 20-30 sec when using a primer pan.
$12 shipped to CONUS
A -16 jet
B - 20 jet
C- SOLD shiney (I was bored) 24 jets.
D - 20 jet
The orange stoves (E -F) are the one piece alum bottle stoves where the bottle is rolled back on to itself. It looks similar to Zelph's Cobalt or the MBD bios 2. No wicks inside or outside. These are Real Tree energy drink bottles and are even thicker Al than the bud bottles and are 2.6" diameter vs. 2.31" for the budlights. These will not fit under a Heine pot. Great for use with an MSR Blacklight setup.
$12 shipped to CONUS
E SOLD - 16 jets. 2" tall. jets about 3/4" from top. a little wrinkled on the inside but works just fine. Angled / dented jets to narrow the flame pattern. This one was vented back to the inside but I epoxied (JB Weld) over the vents.
F - 20 Jets, 2.25" tall. a little wrinkled on the inside but works fine.
PM me with questions or let me know which letter you want.
Bookmarks