Quote Originally Posted by SinisterMinister View Post
Three questions about your diagram:

1. Do you have the hammock body cut as a parallelogram?

Yes, but it is not cut on a 45deg, just pulled back 20 inches, the triangle long side does not match as it does in the drawing

2. Is this a top down view of the hammock body or bottom up?

It would be a bottom up view, if I had better drawing abilities the triangle piece would be dashed lines, showing it was on the other side of the hammock body.

3. I didn't do so well in Geometry class...what does "radius corner to 3 inches" mean?

Basically just find a tube about 3 inches across and put it in the corner and draw a semi circle around it to round off the corner, rather than square it.
Thanks!
Quote Originally Posted by Shug View Post
Yeah....c'mon TZ .....video time)))))))))
Shug the Pushy
My video abilities are not even close to my drawing skills, but I may give it a go.

Quote Originally Posted by Knotty View Post
Will be following this thread and may soon be injecting some thread based on this.
Very interesting!
Yea lots of twisted thoughts here.