I may be slow... But I sure am gimpy.
"Bless you child, when you set out to thread a needle don't hold the thread still and fetch the needle up to it; hold the needle still and poke the thread at it; that's the way a woman most always does, but a man always does t'other way."
Mrs. Loftus to Huck Finn
We Don't Sew... We Make Gear! video series
Important thread injector guidelines especially for Newbies
Bobbin Tension - A Personal Viewpoint
I am 300 lbs and use 7/64". I bought this just because that's what I saw others using and it was rated to hold me just fine. I have had maybe 10-15 nights in the hammock with this setup and have had no issues. However, I can't say I would not go with the 1/8" if I did it again, it would not add that much weight to my pack.
"I will study and get ready, and perhaps my chance will come." - Abraham Lincoln
Has the OP thought of going with a webbing setup?
Less fiddle factor than whoopies (no worries of whoopie slipping off the toggle, no knots to learn, etc.).
If your relatives are just recreationally using a hammock, this may be the better way to go.
Just another option.
Cost of rope is proportional to mass which is proportional to load rating. So, the 1/8" Amsteel will cost you 50% more than the 7/64".
Well, it handles nicer, too, guessing your big bro and nephew don't have hands with slender fingers, either.
But, what is going to break first? How about some stitching? Or maybe you can be sure the line shears the fabric of the hammock under the dynamic load you are afraid of?
I'd think about the kind of mis-use that might occur and what you want to happen as a result. If it is two guys and five hundred lb falling on a hammock which was 18 inches off the ground, would your rather have the Amsteel survive and tear one of the necks off the hammock? Isn't it likely that under that load, if the hammock doesn't fail somewhere, that the nylon stretchs 30% and they hit the ground anyway, no worse damage to them than if they were horsing around, fell, and............hit the ground?
Last edited by DemostiX; 07-06-2011 at 14:55.