Perfect! I will take 2! Please.
Do you think this could function as a toggle of sorts? Maybe keeping an amsteel piece on the hammock that would just loop over this piece? When loaded, the triangle would keep the loop, or loops spread out from tension? Easily interchangeable between hammocks and for packing?
Its basically the same thing, check back in tomorrow around 2pm Ill have test results and info.While I am quite content to sit on the sidelines while y'all get this all worked out, I just can't help throwing in occasionally, sorry...so on this set up might there be some concern about twisting? I like the triangle set up better, maybe?
Jeremy
Good luck,
RED
My Youtube Channel
Deep peace of the running wave to you.
Deep peace of the flowing air to you.
Deep peace of the quiet earth to you.
Deep peace of the shining stars to you.
Deep peace without end to you.
adapted from - ancient gaelic runes
"I aim to misbehave." - Capt. Mal Reynolds
Mind of a Rat Youtube Channel
At present, I only have the one. OutdoorJunkie asked if it could be done with a whoopie sling and I had a down day at work and just came up with this. I did it to see if it was possible. The adjustable loop on this one is only 19".
However, if you are serious, I will make up another one and send them to you. All I ask is for 25' of 7/64" Amsteel. You have to understand that this was a prototype and I make no claims as to how pretty or how well they will hold.
The only problem that I could see with that idea is the tension on the hammock channel. Without tension on the ends of the channel, the hammock will have a tendency to bunch in the middle. If you can figure out how to keep tension on the hammock channel, it would work fine in that fashion.
Ellis
Okay well the holes did not work at all lol, but I found an alternative. I cut a 3 3/4 inch piece of 3/4 inch PVC and made a 1/2 in bevel. Worked great. Here are pics of It loaded on the ladys hammy.
Jeremy
So if the piece that goes thru the channel is the ideal length to maintain tension(which likely would be shorter than the spreader bar)and it has a loop on each end, you would put one loop over and slide to the middle of the spreader bar giving you enough slack to get the other loop on, then spread them both out and they would stay spread by the tension on the triangle created in the suspension? Not sure if that makes sense?
Bookmarks