I would like to add some pull outs to a tarp to emulate the Cloudburst's pull outs locations, for a Rdgerunner.
Does anyone know the exact distance between the ridgeline and the pull outs ? I am guessing something like 33", but I do not have the exact measurement.
Last edited by Rouskof; 11-28-2016 at 12:58.
36" if I recall
ok, thanks.
I'm gonna do the same thing by setting up the hammock, then the fly, in this case, a Mamajamba, making sure it's centered, and then letting the fly hang down until it touches the pole ends of the hammock. These are the points I'm going to install the pull out clips (sold by Dutch). Seems to make sense to me and no measuring required.
Sent from my Nexus 6P using Tapatalk
Ye, except I don't have the hammock yet, and want to buy the tarp with the pull outs sewn.
Brandon corrected : 33" between the pull outs and the ridgeline on the Cloudburst.
Do you mean the distance between the panel pull outs (to line up with the ridgerunner head end and foot end spreader bars)? Or do you mean the distance between the tie outs? If you are talking about the panel pull outs I used 78" for my OMW tarp.Originally Posted by Rouskof
Distance between the pull outs and the ridge line (vertical measurement, not horizontal)
33" down from the ridge seam is the correct measurement, it is about 23" down from the seam on the SF, Edge, and MJ
Last edited by warbonnetguy; 11-30-2016 at 17:18.
Right, post corrected
Posting Permissions
Reply With Quote
Bookmarks