Hello all,
A quick question, I've tried searching the forums, as I'm sure it has been covered, but couldn't find the answer.

I'm getting ready to start my first DIY hammock, planning on a WarBird type. My question is regarding the bottom sheet width. I have been able to find some good material in my area (Tokyo), but the width is only 122cm(48"). The plans I have found call for ~60". Is it possible to use a seam on the bottom piece to achieve the desired width?

Would the seam have any negative effects, strength, comfort? Also, if it is possibe to use a seam, where should it go? down the middle? down the left/right side? two seams?

Thank you in advance! This forum is tops!