Use stainless hardware and don't skimp on the fender washers. Quite a bit of force is applied and the bolts tend to bend a bit over time. I've also teardrop mortised my upright with their supports. This is done by trimming a teardrop notch in the upright where a mirror cut end on the stanchion mates.
[IMG]hammockforums.net/forum/attachment.php?attachmentid=11148&stc=1&d=12753123 17[/IMG]
the tension of the hammock lines keeps the joint in position without the need for a bolt in the joint- eliminating the issue of bent bolts being hard to pull and reinstall for takedown. Further weight applied in the hammock further solidifies the joint.
Bookmarks