Help adding panel pull outs

[aboyd]

I am getting ready to venture on a new tarp, using the Argon sil fabric from Dutch. It won't be my first tarp, but I want to add side pull outs to this one. I am looking for ideas on how to approach this. I plan to test it out on my current DIY tarp, which is 1.1 sil. I have searched and seen a few options, and I like the looks of this one I found in another thread, I believe this is on a Warbonnet tarp.

IMG_4059 (Medium).JPG

Any opinions on how this holds up? Other options? I will continue my search, but thought I would throw this out for advice. I plan to do an external pole setup, like the pic above, most likely.

[The Old Boot]

Unfortunately I don't have close up pictures of the pull-outs I did for my tarp.

BUT the one thing I did was to put both pull-outs on the outside and in the exact same spot on the inside I put pockets for doing inside poles.

I wasn't sure which I was going to be using so to make the tarp as versatile as I could right from the start I put them both in place. They also serve to reinforce each other.