So, long story short, I was smoking in bed while on the trail, and the wind caught some ashes. The ashes went right through the BMBH like a hot knife through butter, and now I have two holes, one in each bottom layer, the size of a cigarette.
I wasn't hanging at the time, just set it up on the ground for bug net purposes, and I haven't dared hang since.
So...how do I fix the holes? Is it enough to just patch them up? I'm a little nervous about this, it would seem to cause a whole lot of stress on the fabric and the whole thing might rip if I hang. The holes are about mid section, right where you sit down to climb into the hammock.
Or do I make a long patch along the whole side of the layers?
Or do I change the entire two bottom layers?
I'm such a clutz...
Bookmarks