I thought I'd give this a try.
3.5m of olive green pertex 4. Hemmed on two longer sides and a channel on each of the two shorter ends.
6mm Dyneema is currently being used but I have some 5mm on its way.
Cord was thread through each end cord and cinched up nice and tight, looped around and a square knot tied up nice and tight.
A short length of the same cord was attached to the hammock with a larks foot below 1st bit of cord.
Will it hold?
it holds nicely, although the wall posts of the new house are a little low, therefore the hammock is suspended much lower than I would normally have it.
It holds nicely!
It is super light weight. Just going out to take it down and weigh it,
Bookmarks