Where can I find the rope used here in a 50 foot hank?
Where can I find the rope used here in a 50 foot hank?
Try you may, fail you might. -unknown
Amsteel Blue...use FREEXMAS as a discount code and get free shipping through 12/16/12.
I like the set-up. I use the rings in almost the same way. I made my own whoopi type slings using "mule tape" a 2000lbs. poly-nylon flat rope used by the electrical underground
industry to pull long heavy cable thru conduit. mule tape is half an inch wide and and 1/8 inch thick. It does not work well as a tree hugger...it snags on the bark.
I just finished reading through all the posts in this thread (even my earlier!) and I have an idea that I'd like to run by folks.
The setup I'm thinking of using has a mainline of ~40' of 1/8" Amsteel, four nacrobiners (made from 1/8" Amsteel) and a set of tree straps.
My present hammock has an ideal hung spread of 85". So, I would tie two butterfly knots, centered on the line, so that the ends of hitching loops are 85" apart. That would allow me to hitch my hammock (using nacrobiners) to the loops on the butterfly knots at the same angle that I like. Since I'm establishing my ideal length between the ends of the hitching loops, I can play with the length of those loops to adjust how high the ridge line is above me (6" loops would put the ridgeline higher than 1" loops)
Next, On each end of the main line I would install what would end up being 4-5' whoopie sling loops. These would attach to the tree slings with the other set of nacrobiners.
Here's what I'm thinking:
1. I know that 85" is where I want to be, so why not make that static on an unstretchable line that is heavy enough to take some serious pull?
2. By putting in-line whoopie slings on each end, I have some play in length and for centering the hammock between hang points.
The only points that I still have questions about are the nacrobiners. All that I've read about them suggests they should be more than strong enough for the load, but I have yet to do any practical tests.
What are your thoughts on all of this? Do you think that a nacrobiner would be weaker than the mainline itself? Is 1/8" overkill and 7/64" should be heavy enough? Are there any reasons to not make the hitching points static, if I know what spread I need to get the sag I like?
mrmike. I did something that sounds similar to your description https://www.hammockforums.net/forum/...ght=olddog%27s My hammock and huggers both use nacrobiners in the suspension with no problems. The main point to keep in mind about the SLS systems is that the loadings are much greater than other suspensions hanging at 30 degrees. MADD777 had been trying to impress on me the tremendous loads with the SLS and it didn't sink in until a poorly stitched hugger let loose. For attaching the hammock and tarp to the SLS I use a buried sliding loop, thought it was something new but as near as I can tell it's a UCR.
Most of us end up poorer here but richer for being here. Olddog, Fulltime hammocker, 365 nights a year.
Nice post HC4U - I wish I'd read it before last night, when I used up all my amsteel making a different type of suspension... Oh well, Scott won't mind another order, I'm sure!
To become Old and Wise, First be Young and Foolish.
"A man who will not read, has no advantage over a man who cannot read." - Attr. Mark Twain
so was wondering who all was still using the sls and if there was any signs of amsteel weakening area of the metal ring
Bookmarks