I posted once on it, look here. Tells you what to do, but no suggestions on how to do it.
In words. Maybe get a piece of paper and a pencil....think of the dart shown, two edges, equal length, coming together at a point. We can easily measure the endpoints of the lines. The line that cuts the long edge is placed in such a way that when both such lines are placed the distance between those endpoints is the width of the spread. The endpoint that intersects the shorter edge does so 3/8" from the top edge. So, for a given dart, fold the fabric over so that the endpoint on the short edge overlays the endpoint on the long edge. Now if you take a ruler and lay it out on the doubled fabric so that the ruler edge passes through the overlaid points and extends up and crosses the fold, note that any place we place that ruler, if we were to cut along that line we would create a dart with exactly equal side lengths. By experimenting I've found that 17" length is good for the head, and 14" is good for the foot.
Now I don't really cut along that line. Instead I draw a line on the fabric, pin the two sides together, and run a stitch along that line. THEN I cut, just offset from the line a little.
OK, maybe you can wait for the movie version....
Yes, I do a lot of experimenting with hammocks and it is a lot simpler if I don't have to create a new suspension with every one of them.I like the removable suspension. It was fun putting all that together once, but if I build another it would be nice to switch out. Next time I guess....
Thanks. There is a price paid for that splice (x2), you increase the minimum distance between trees that you can easily hang. But there definitely is a pleasing aesthetic to it.
Excellent! Your first homework is to draw a diagram for krugd of the explanation I gave him on making the endcap
seriously though, I appreciate the sentiment coming from the Dutch Master.
Well thanks....what good is an idea if I don't share? In this hobby space I've no designs on any intellectual property. Have the ideas used is the reward. "Impact" we call it in my day job.
I think a double bodied hammock with thicker webbing suspension and speader bar (questoutfitters has an even heftier version of what I use, but would be 34" rather than 36" wide) would support you. I learned to sew making bridge hammocks....you could too...a thought....
Nuthin fancy there. One line is buried into the other. The bury is started with a locked Brummel. You know how that goes...line A passes through line B, and then very close to that line B passes through line A. Before you tighten things up and finish the bury there is a hole formed by A going through B on one side, and B going through A on the other. I threaded a length of Lash-It through that hole, then finished the bury. I put a double fishman's knot in the Lash-It to form a loop. Now the ridgeline is also Lash-It, which makes differentiation a bit hard to see. But all that is done at the end shown in the video is to have a bowline loop in the ridgeline, pass the bowline through the cord ring embedded in the suspension, and pass the standing end of the ridgline through the bowline.
OK, maybe you can wait for the movie version too....
Bookmarks