Caldera Clone w/ "Flissure" Joint

[Sweeper]

This was my last go at the CC generated by the postscript code. This version utilizes a "flissure" joint, per it's creator, Captain Paranoia over on OM. It was a bit tricky to cut the template out, and I'm still not exactly sure on the handle side layout, but the end result was a two-piece CC that should stow away much more compactly. I built this one to mate with an Evernew T1 .9L pot and an old Brasslite Duo stove I have. The good news is that if I can do this project, anyone can. It's not nearly as hard as the sewing stuff our DIY whizzes do!



http://www.hammockforums.net/forum/p...pictureid=2197



Sweeper

[VegaMike]

Sweeper, I have the exact pot, the Evernew Ti Ultralight Pot 2, model ECA-251 (5.35in diameter x 2.52in height)! I like the two-piece design. It will be interesting to see if it fits in the pot.

What are you using for a stove?

Hardware cloth height?

Thanks!

Don't know what we're talking about? Sweeper's post on Outdoors Magic (UK forum) is here (you may need to scroll down).

[Sweeper]

VM, it doesn't quite fit, just barely. I am using a Brasslite Turbo Duo, so the hardware cloth is fixed (spot welded) to the stove. The Stove height is 1 3/8" tall and the hardware cloth is 1" for a total of 2 3/8. I am going to use a smaller stove height wise (maybe a MBD mini-atomic with screen and see if that brings it down to the proper height. I'm so close to having this as an all in one!

Sweeper