-
Cuben GrizzBeak
Last summer I put together a GrizzBeak, made from cuben fiber, to be used with a (then) newly acquired MacCat Delux in cuben. It was all pretty straightforward so I didn't figure it warranted a posting, but here russmay pointedly asked for details, so here they are.
I have some CT2K.08 in olive, roll width is 54". This pushes the template to have either the front or bottom edge be 54". It worked out that both were, with a 6" overlap at the top. Here's a template.
http://www.hammockforums.net/gallery...ak-5_thumb.jpg
I rolled the edges everywhere and ran a stitch to hold them, except where the two pieces of the beak come together. There I used double-sided tape I got from questoutfitters.
http://www.hammockforums.net/gallery...ak-3_thumb.jpg
To re-enforce the corner attachments I bonded and sewed into the rolled edge a small bit of 1.9 oz/yd nylon. I made corner tabs from grosgrain and
attached at the edges with a single bar-tack (although there are stitches to hold down the grosgrain along the tarp-side corner, they aren't holding much.)
http://www.hammockforums.net/gallery...ak-2_thumb.jpg http://www.hammockforums.net/gallery...ak-1_thumb.jpg
Packed down the beak has the volume of about 2 decks of playing cards, and with the cord at the corners comes in at 2.25 oz.
http://www.hammockforums.net/gallery...ak-4_thumb.jpg
It's a nice light addition to the pack that gives a lot of protection from wind and rain at what would otherwise be an open end of the tarp.
-
Sweet ... you do mighty nice work Professor!
-
Salivating over these in TN !!!!
No I wont say it Grizz but you can read my mind!
-
Wonderfully straightforward directions!
-
Thank you very much, nice, easy instructions.
-
Thanks Grizz, I'll have to order some cuben now.
-
Grizz...I'd love to see some photos of it on the McCat Deluxe. Thanks
-
As usual, Very Nice Grizz
Thanks for the modified template
-
Awesome Grizz, simply awesome! Now I gotta find out how I can get a set :D???