Attaching ridgeline

I've got my DIY camo hammo set up with whoopie slings and an Arowhead whoopie ridgeline. The ridgeline has loops spliced at both ends, so I just made a loop back on itself and slipped the whoopies suspension through this and let it tighten where the whoopie attaches to the hammock end. This is working just fine, except I have to loosen the ridgeline loops to adjust the ridgeline whoopie, no big deal. Only problem is the ridgeline is only a foot or so above my head when I am laying in the hammock. Would like to have it a little higher. Is there a better way to attach it? I think you can see how it is set up in these pictures.

http://i133.photobucket.com/albums/q...ammock/lay.jpg

http://i133.photobucket.com/albums/q...ck/sitting.jpg

I'd suggest more sag...shortening your ridgeline will essentially raise your ridgeline height

I know this is obvious, but more sag will raise the ridgeline.

My setup is similar to yours and my RL is about 15" above my face.

There are a couple "pigtail" solutions by splicing an eye or tail in the whoopie. I want to spend a little time thinking about it before I post it. On the surface, I'm not comfortable with 8 strand 7//64" line and side loading it nor splitting the braid.

Normally, ridge line failures do not cause any immediate danger, but once we start putting it in the suspension, it may cause a suspension failure.

A simple test would be to prussic your ridgeline to your whoopie sling with a prussic that will fail first. Maybe use a strong braided mason twine (180#) or Lash it/Zing it. The green braided mason twine at Walmart in the fishing section for trot lines is 180# test.

You could try shortening the ridgeline. You might get a more diagonal position that's flatter that way, too. Alternatively, you can attach the ridgeline to the hammock lines a little way above the hammock ends.

Try making the SRL 83% of the length of your hammock as a starting point and then adjust to your preference. It looks like you are inline with the hamock. As others have said, more sag may be needed.

Thanks all. If I move the RL up the whoopies will it slip? Hammock is just a little short, so this might be as good as it gets. It's working just fine, but would rather have some more room under it for reading with my arms extended. I've started keeping this in the car, last weekend spent a couple hours waiting for my sons at a state park day use area. Set the hammock up and spent a relaxing couple of hours lounging in it. Takes about 30 seconds to set up and take down. My new best friend!

man, you wear some bright shirts. thats awesome.

the way mine is setup i have my suspension whoopies running to descender rings that are connected together by the ridgeline. i then have continuous loops from those descender rings to the gathered ends of my hammock.

This setup allows me almost two feet of space above me to the ridgeline (arm fully extended to reach while laying). I dont know if you would want to go this route or not but it works great for me, esp in bugnet season.

I like the idea of using the rings, but how are you going from the hammock to the ring? Guess a short piece of Amsteel with a loop on each end would do it??

That shirt is a Brooks Nightlife, I often run late at night and want to be visible. On the trail, I want folks to find my carcass before it starts smelling too bad
;-)

Quote:

---

Originally Posted by Big Jim Mac

I like the idea of using the rings, but how are you going from the hammock to the ring? Guess a short piece of Amsteel with a loop on each end would do it??

That shirt is a Brooks Nightlife, I often run late at night and want to be visible. On the trail, I want folks to find my carcass before it starts smelling too bad
;-)

---

Yes a loop or a short eye to eye sling. The 83% for a gathered end will not ring true if you go from ring to ring. You would essentially be mimicking the single line suspension idea but not using a single line. Perhaps the SLS is something that may tickle your fancy. I believe there is a sticky up top about it.

Hello Big Jim Mac, I had the same trouble when I installed a ridgeline on my Grand Trunk. The ridgeline was just too close to the hammock for my comfort. Problem solved!

http://www.hammockforums.net/forum/p...pictureid=4712

I believe i got this method from Hawk-eye.
A pair of chain links from AHE (continous loops of amsteel) larks-headed to the hammock to a Dutch Biner.
Ridgeline connects to the Dutch Biner - this raises the ridgeline height nicely.
Whoopie slings from Biner to tree straps.

I couldn't be happier with this setup, I suspect I doubled my hammocks comfort!

Quote:

---

Originally Posted by Ozzy

I believe i got this method from Hawk-eye.
A pair of chain links from AHE (continous loops of amsteel) larks-headed to the hammock to a Dutch Biner.
Ridgeline connects to the Dutch Biner - this raises the ridgeline height nicely.
Whoopie slings from Biner to tree straps.

I couldn't be happier with this setup, I suspect I doubled my hammocks comfort!

---

Ozzy, is that a fixed length ridge line or an adjustable?

This is an adjustable ridgeline I made myself. With the how-to videos and pics made available on this site its easy as pie!

Ozzy, do you have any more pictures you could post? Specifically, I would like to see where/how you attach your mosquito net pull outs. Have a SB Pro on the way and would like to see what I am up against....

Hey Buffalo Soldier, I think you made a good choice with the SB Pro.
After perusing my photos I don't have any that are as helpful as Te-wa's. Search "skeeter beeter mods and pics". He has a better system than what I have done so far.
I normally run the supplied shock cord through the sewn in elastic loops on the netting and attach each end just above my tree straps. A few minutes of searching the area always results in two lightweight sticks I use as spreader bars between the elastic loops.
Some have suggested running the ridgeline THROUGH the netting but I choose not to as I love flipping the hammock over and going net-free. Being from Florida net-free may not be an option for you, making this a viable approach.
Enjoy!

Excellent. Those last two are exactly what I was looking for. And I must say, that is exactly how I had envisioned handling the netting.

Actually, where I am is not necessarily so bad. Our climate is cool enough from November through March that we get nights below freezing and days in the 50s, so bugs during that time are low at best. We do much of our backpacking around here in the winter, as dragging a pack of any weight in weather in the 80s+ and humidity over 90% is just plain miserable. But I do camp year round. Aferage summer nights are about 78-80, so the coolness of the hammock is a blessing. That is when I need netting.

Can't wait to get this rigged and try flipping it over. I think I can rig the netting supports to be easily removable.

Does anyone else have any suggestions of how to hang the netting on the Grand Trunk SB or Pro? Here are the original pics Ozzy referred to:
http://www.hammockforums.net/forum/s...ead.php?t=4669

OK, now another question. I just finished my whoopie slings, and I finished a adjustable ridgeline/whoopie. If I am trying to get this a little higher above the hammock, can I attach it to the whoopie with a Prusick knot on either end? Will this be secure enought for a ridge line? Will is compromise the rest of my suspension in any way?