integral bug net
To test the feasibility of sewing a bug net on the bottom of my zhammock, I got an idea. DOH! <G>
I climbed inside the doublle layers and pushed the top layer up, as if it was the bug net. It worked just fine. There is plenty of room.
So: I will need to sew tabs to the bug net to run a ridge line through when using the bug net mode. How it this done?
Do you sew a loop in some grossgrain and then sew the ends to the mesh? Do the big boys sew reinforcement on the inside?
My Byers Mosquito Traveler had these loops, but I can't for the life of me remember any details.
I plan on locating the loops at around neck and knee position. Does that sound right? Then I will sew the zipper to the bug net, the bug net to the zhammock on three sides and finally the fourth side and zipper to the remaining hammock long side.
TIA for any pertinent advice