Warbonnetguy...sorry I never answered your question from page 1...I experimented with liquified plexiglass and Minwax Wood Hardner...the plexiglass is liquified in acetone...then pulled to about 19 to 20 inches of vac...more than that and the acetone starts to boil. Once these #'s are acheived...you valve off the vessel and allow the wood to soak until it sinks...anywhere from 12-24 hours. Allow the vessel to come back to atmosphere and remove the soaked wood...the acetone is then allowed to dry at room temp or you can bake it out in a few hours at low heat.
If you were to try the sil nylon in this fashion I would pull the vac until you see the Mineral Spirits boil...then release the pressure...note the boiling point or look up the BP on the internet and keep the vac below this #. Submerse the nylon and pull the vac and valve off...allow it to "soak" for a while...then remove and dry.
just a thought.
Acts 10:13 "Arise Peter, Kill and Eat."
Job 14:15 "Call upon Me and I shall answer you."
Williams Custom Calls