I've always suspended my tarp below the ridgeline for the reasons stated above, abrasion and water. As others have also stated, HYOH. Hang it above and hang below then figure out what works best for you.
I've always suspended my tarp below the ridgeline for the reasons stated above, abrasion and water. As others have also stated, HYOH. Hang it above and hang below then figure out what works best for you.
Has anyone that hung their tarp on top of their ridgeline, noticed any abrasion?
I’ve been hanging tarps directly on top of ridgelines, for ten years, and have never noticed any abrasion, although I’ve not specifically looked for any abrasion. I try to hammock camp at least 12 times a year. That’s about 24 nights a year.
I just spent a year hammocking in a windy desert. During that time, when the wind was pre-rain, I would often put my tarps over the ridgeline to keep it from ripping at the tieouts. That did happen to one of them.
During that time the only wear I noticed was on an older tarp that had the ridgeline seam taped. The tape, which was dry (like everything out here) and starting to crack, caught on the ridgeline while it was being blown about and added some to the peeling.
"Sent w/o me knowing"
Thanks LowTech for giving us in the field observation of your tarps over time.
For the tarp I use a continuous ridgeline with, I put it under the ridgeline. I became a believer in abrasion when I took a tarp on a bike tour on gravel, and the vibrations in my pack caused the guy lines (which were a somewhat stiff dyneema blend) to rub right through the stuff sack. I’m just lucky it was the stuff sack and not part of the tarp that got the damage.
Sent from my iPad using Tapatalk
You know, there is another solution that avoids knots!
I was on this same path looking to avoid knots for my non scouting friends and finding a solutions when I realized there is some great hardware available that can solve this problem. Also, the benefit is to lessen the sag that you get when using a continuous ridgeline and place the tarp underneath.
Anyway, Superior gear's tarp has a unique setup but it doesn't look like you can purchase it on their site separately yet. If I'm wrong I'm so sorry. It has an adjuster on each end of the tarp and then two small carabiners to go around the tree. It works like a charm and so quick to set up.
What I started doing for my non knot friends is to utilize two dutch fleaz https://dutchwaregear.com/product/fleaz/ Tie one end to each end of your tarp and then just adjust the flea to the right setting. It is super easy and no knots needed.
You could also do the same thing with a nama claw https://www.namagear.com/shop
That sounds equivalent to a LineLoc3 on the tarp with minibiners on the end of the split ridgeline. The WiseOwl tarp came with LineLocs preinstalled so doing something like that should be fairly easy.Anyway, Superior gear's tarp has a unique setup but it doesn't look like you can purchase it on their site separately yet. If I'm wrong I'm so sorry. It has an adjuster on each end of the tarp and then two small carabiners to go around the tree. It works like a charm and so quick to set up.
I've been using a CRL with my WiseOwl and I much prefer it to the split ridgeline. I almost always send the tarp over the ridgeline though since I like to clip things onto the ridge line itself. It's funny though, I don't think I've experienced water going down the CRL. It may be that the unused LineLoc on the ridge tie-out is acting as a water break, or the two part hennessy snakeskin which is bunched up at each end doesn't let the water flow in. As for abrasion, I usually end up clipping at least a pounds worth of stuff onto the line so even though the ridgeline is taught, the CRL itself will hang a bit below it. I'm using a reflective cordage for the CRL so perhaps the abrasion factor will come up when I'm not weighing it down. Either way, I keep the CRL and tarp packed in different areas of my pack so I certainly wouldn't expect any wear while traveling unlike JollyRoger.
Bookmarks