Hey again everyone!

Ive been working on a way to simplify the tie-outs for my tarp, and finally came up with this option...

I pushed a loop of the tie-out cord thru a cord lock.

I attached a small lanyard snap-hook to this loop.

I attached a very small (smaller than a dime) split ring (looks like a keychain ring) thru the hole in my Ti pegs.

I just snap the hook to the ring and adjust the tension on the cord lock.

Attached photo. It shows the cord lock real close to the snap hook... I dont normally have it this close, just for photo puroposes, so that some of the excess cord is taken up off the ground...

Does anyone use anything similar? What do you use? Any comments/modifications I can make to this set up? I did this looking for ease of set up/take down...