I thought I'd give this a try.

3.5m of olive green pertex 4. Hemmed on two longer sides and a channel on each of the two shorter ends.



6mm Dyneema is currently being used but I have some 5mm on its way.



Cord was thread through each end cord and cinched up nice and tight, looped around and a square knot tied up nice and tight.

A short length of the same cord was attached to the hammock with a larks foot below 1st bit of cord.



Will it hold?





it holds nicely, although the wall posts of the new house are a little low, therefore the hammock is suspended much lower than I would normally have it.

It holds nicely!





It is super light weight. Just going out to take it down and weigh it,