Quick question.
How does everyone finish the rolled corners of their bridge hammocks? Obviously when the webbing is rolled into the sides, the ends are unfinished. What is a good way of finishing these corners? I have heard of angle cuts, this doesn't finish the fabric edge. Any ideas?
Normally you would roll hem the ends before you roll the fabric on the webbing.
You may have seen posts where I made the end caps in the same pattern as the main body. I don't roll the end on those. I edge the ends with ribbon or make bias tape out of some scrap fabric. This design needs a peice of shockcord run thru the edging to keep the ends up.
Posting Permissions
Reply With Quote
Bookmarks