Sorry for asking a question I am sure has been answered somewhere here already. I did a bunch of reading in the ring buckle support thread and couldn't find the answer so here goes.
I like the rings and straps I have been using and have decided to remove the HH stock ropes so I can put continuous loops and rings on them. I am aware that, because of the two holes I have to go through, the double wrap, and the prusik on the double omega pacific rings, I need a longer loop then the standard 12 inch. I was wondering if anyone could tell me how much longer. I am using 1/8 inch amsteel ( I know that will make a little difference too.)
I made a couple up using 48 inch lengths of rope and though they are 17 inches finished length they come up short. If no one knows for sure I will continue experimenting until I get the right length and report back.