Page 3 of 3 FirstFirst 123
Results 21 to 29 of 29
  1. #21
    Senior Member greggg3's Avatar
    Join Date
    May 2007
    Location
    ohio
    Hammock
    HH Deep Jungle Zip XL
    Tarp
    MacCat deluxe
    Insulation
    down
    Suspension
    whoopie sling
    Posts
    243

    Talking

    Quote Originally Posted by HANGnOUT View Post
    I have the amsteel 7/64 that Coffee uses and I have had no success with the garda hitch. I have some covered in paracord sheath (PIA not worth the time) that worked and I got some 2.8 spyderwire that works great. The amsteel would flatten out without the sheath and slip. It would look like flat webbing after being in the rings.
    I just got some amsteel, and your right - its the first cord I've ran upon that won't hold with the garda hitch at all. Its so slippery! What I ended up doing that seems to work, is using the munter mule
    http://www.animatedknots.com/munterm...mage=&Website=
    this works! There is a little slip as the munter knot turns over but the amsteel line is so small that the slip is almost not noticeable. And it unties easily if you use a slip knot.

    This Amsteel is stronger, lighter ( and softer - not sure why that would matter?) and with the munter mule I only need one ring!

    There is someone else on here that uses the Garda Hitch (can't remember who), anyway whoever you are - check out the munter mule - only need one ring and it seems to work ok on slippery lines.

  2. #22
    Senior Member hangnout's Avatar
    Join Date
    Nov 2006
    Location
    Monterey, TN
    Hammock
    DIY Bridge
    Tarp
    DIY Tarps
    Insulation
    Leigh's UQ's
    Posts
    1,789
    Images
    123
    I just got some amsteel, and your right - its the first cord I've ran upon that won't hold with the garda hitch at all. Its so slippery! What I ended up doing that seems to work, is using the munter mule
    http://www.animatedknots.com/munterm...mage=&Website=
    this works! There is a little slip as the munter knot turns over but the amsteel line is so small that the slip is almost not noticeable. And it unties easily if you use a slip knot.
    I had tried that before but not like the example on the bottom of your link. Seems that small line needs to be wrapped around the ring a few times then go to the slip knots. Thanks for the link I am going to try it tonight.

  3. #23
    Senior Member greggg3's Avatar
    Join Date
    May 2007
    Location
    ohio
    Hammock
    HH Deep Jungle Zip XL
    Tarp
    MacCat deluxe
    Insulation
    down
    Suspension
    whoopie sling
    Posts
    243
    Note that its not just wrapped, the munter knot can be used for rapelling/belaying if you lose your rapel/belay device. When its tied correctly, it flips back and forth depending on which way the rope is moving. With climbing rope diameters, when it flips back and forth, the rope pays out an inch or two, but with the thin amsteel, it seems like less than half an inch which is close enough to not be noticable to me. Now my support line is very very light (lighter than the tree huggers) and I only need one smc ring.

  4. #24
    Senior Member hangnout's Avatar
    Join Date
    Nov 2006
    Location
    Monterey, TN
    Hammock
    DIY Bridge
    Tarp
    DIY Tarps
    Insulation
    Leigh's UQ's
    Posts
    1,789
    Images
    123
    Yeah, I like it. The temps tonight are going close to single digits so I am going to do some testing. Might as well test this too. I have been noticing some fraying on the cover of my line when using the garda hitch. It really clamps down on the line and any movement cause wear. This may be the best solution. I think you got me started on the garda hitch with a post way back when and now this one.

  5. #25
    Senior Member hangnout's Avatar
    Join Date
    Nov 2006
    Location
    Monterey, TN
    Hammock
    DIY Bridge
    Tarp
    DIY Tarps
    Insulation
    Leigh's UQ's
    Posts
    1,789
    Images
    123
    This did work well and is a way to lose two rings if you want to use bare spectra. I did it slightly different. Instead of finishing by wrapping around the ring a few times I went directly to a couple figure 8's around the ring and rope and finished with one slip knot. Just seemed easier to keep from slipping while wrapping with gloves on. You do lose the quick fne tuning capabilities of the garda hitch. Thinking about a garda hitch on one end and the munter hitch on the other. This would allow quick tightening for any stretching etc.

  6. #26
    Senior Member greggg3's Avatar
    Join Date
    May 2007
    Location
    ohio
    Hammock
    HH Deep Jungle Zip XL
    Tarp
    MacCat deluxe
    Insulation
    down
    Suspension
    whoopie sling
    Posts
    243
    I agree, I like the Garda best for adjustablility, but I can't get it to hold on the thin amsteel which has no outer cover.

    I finish the munter without wrapping, just tie the munter, pull it until its as snug as I want then just tie the slip knot around the taught line right up close to the munter. Seems to hold fine and if you want to readjust, a quick tug on the slip knot and your back to just the munter.

  7. #27

    Another option currently sold by the foot: Nova Lite HP

    Since many of the links in this thread have rotted and someone else might care... I damaged a line (my fault) and Hennessy replaced it under warranty. But before I worked that out with them, I found that Nova Lite HP 3/16" I can buy for $0.52/foot from http://rwrope.com/novabraid-novalite-hp.html and seems to meet specs http://www.novabraid.com/rope/novalight-hp.html 1459 lb tensile strength. I have no experience with the rope and didn't buy it after all due to the replacement, but it looks similar to what Hennessy use. Spyderline is still available but I see it only by the reel, not by the foot, so if you want less than a reel, the "Nova Lite HP" (N.B. "Nova Lite" is totally different) was all I could find by the foot. YMMV, no warranty, etc.

  8. #28
    fallkniven's Avatar
    Join Date
    Oct 2011
    Location
    NJ
    Hammock
    JRB BMBH
    Tarp
    Superfly
    Insulation
    UGQ
    Posts
    2,686
    Images
    1186
    Hope you noticed this is 8 years old. Lots has come out since then...

  9. #29
    Senior Member joe_guilbeau's Avatar
    Join Date
    Mar 2013
    Location
    San Antonio, Texas
    Posts
    193
    Images
    1
    Yep! This here is riggin... I am sure that this was rigged just after the birth from White Blaze...


Similar Threads

  1. Hennessy spectra cord
    By etsisk in forum Suspension Systems, Ridgelines, & Bug Nets
    Replies: 7
    Last Post: 07-07-2014, 08:17
  2. Spectra cord: Z-line vs No Tangle
    By OCDave in forum Suspension Systems, Ridgelines, & Bug Nets
    Replies: 7
    Last Post: 06-05-2013, 00:10
  3. Spectra Cord
    By cshama in forum Suspension Systems, Ridgelines, & Bug Nets
    Replies: 2
    Last Post: 05-04-2009, 07:42
  4. hennessey hammock spectra cord
    By neo in forum General Hammock Talk
    Replies: 27
    Last Post: 11-03-2006, 12:10

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •