"Every day above ground is a good day"
Ok so not to far from Atlanta. Sounds like fun.
no slipping at all that way.
don`t leave the CREATOR out of the creation!
Thanks for the picture. The knot is cheap insurance. I am one of those people that always make sure the straps are lined up in the buckles and still had it slip.
I have only had my buckles try and slip once, but that was because of misalignment of the webbing. I also use a slip knot. It only takes an extra second or two to tie and gives me peace of mind.
“Light thinks it travels faster than anything but it is wrong. No matter how fast light travels, it finds the darkness has always got there first, and is waiting for it." -Terry Pratchett
Premium Quality, Fresh Roasted Coffee
“I think that when the lies are all told and forgot the truth will be there yet. It dont move about from place to place and it dont change from time to time. You cant corrupt it any more than you can salt salt.” - Cormac McCarthy
well here is my first ring buckle hang report:
just got my straps from Strapworks yesterday which was sooner than expected so I took the rest of my trial setup up to the park for a hanging test -
the parts : Trek Light hammock, with S hooks replaced with SMC descender rings, 2 15 ft 1 inch wide polyester straps from Strapworks - note attachment of rings to hammock rope was with a larks head - did not have to untie the rope in the hammock - just slipped the S hook out and put the rings on working with the bight
tied the straps to the trees with a round turn and two half hitches like I used to do with the old Safari Deluxe (a strap based support system) that I started hammocking with - note second half hitch is slipped to make it easier to untie - note no 'biner or loop needed
tied the hammock to the straps by feeding a bight of the strap through the rings in the normal ring buckle fashion, adjusted the hammock (real easy with the rings) then fed the bight down through the center of the rings to keep it aligned - I don't remember where I heard about this technique for minimizing slippage - it might have been here - I vaguely remember it from some article on slack rope (strap) walking.
rested in the hammock for about an hour - no problems with slippage or with untieing the ring buckles - the lack of slippage may have been due to the sag angle I used - I wanted to get reasonably flat in the hammock on the diagonal so I hung it with considerable sag
next step is to try a ridge line and see if it still works with the bight through the ring buckles with a tighter setup
Last edited by jlb2012; 08-18-2007 at 20:00.
I am going motorcycle camping next week up to Maine. This got me motivated to get parts for the ring buckle supports. I had already bought a gob of strap (100 feet+) .I found some welded steel buckles at Home Depot and some carabiner type connectors.
When I got home, I weighed the carabiner things and they were heavy. I took them back this morning
The purpose of the carabiner is only to avoid having to thread the strap through the loop, right??
I now have my hammock strung up on my porch, using the four loop method that I have been using with a rope. That works fine.
I got to admit that changing sag is beyond easy.
I don't see the carabiners weight being justified from the backpacking point of view. But that's just me.
All in all, a nice upgrade.
Miles of Smiles