Page 2 of 2 FirstFirst 12
Results 11 to 19 of 19

Thread: Tarp "Slack"

  1. #11
    Senior Member Syb's Avatar
    Join Date
    Nov 2010
    Location
    Charlotte, NC
    Hammock
    DIY bridge hammock
    Tarp
    OES/WB Superfly
    Insulation
    Incubator/Burrow
    Suspension
    WB Straps
    Posts
    1,697
    Images
    44
    Can you take pics of the tarp ends?
    Syb
    Enjoy the elevation

  2. #12
    Member JakobW's Avatar
    Join Date
    Sep 2012
    Location
    Burlington County, NJ
    Hammock
    DIY Ripstop
    Tarp
    Kelty Noah 12
    Insulation
    HG 20* Incubator
    Suspension
    Whoopie Slings
    Posts
    91

    I just went out, unstaked the sides, and snugged it up. It seems ok until I stake it out. Could this mean I'm staking too far out, and pulling the side seems to the point that they pull the ends closer?

  3. #13
    Senior Member zukiguy's Avatar
    Join Date
    Oct 2009
    Location
    Space Coast FL
    Hammock
    Warbonnet Ridgerunner
    Tarp
    Superfly
    Insulation
    Lynx or Pads
    Suspension
    Straps and Biners
    Posts
    2,397
    Images
    8
    I get something similar with the Expedition tarp regardless of how I have it rigged. I works a lot better with a nice tight continuous ridgeline but it's still far from ideal. The "asym" shape doesn't lend itself to a very nice tight pitch. If it were an actual square or diamond shape it would be better from a pitch perspective (and being cat-cut would help immensely).

    For now, just get everything as tight as you can (within reason) and it will pull out the majority of the flap. So long as the wind doesn't blow your tarp away you'll still stay dry. Good luck.

  4. #14
    Member JakobW's Avatar
    Join Date
    Sep 2012
    Location
    Burlington County, NJ
    Hammock
    DIY Ripstop
    Tarp
    Kelty Noah 12
    Insulation
    HG 20* Incubator
    Suspension
    Whoopie Slings
    Posts
    91
    It seems to have a little less flop after tightening it just to the edge of my comfort zone. It's no where near as bad as earlier.

  5. #15
    Senior Member Alamosa's Avatar
    Join Date
    Aug 2010
    Location
    Bozeman MT
    Hammock
    WB RR
    Tarp
    12' Winter Shelter
    Insulation
    Quilts
    Posts
    1,166
    I don't think that whoopies are a good solution on a tarp. You need to be able to put some tension on the lines and whoopies don't allow that. Figure 9's and Tarp Flyz are a couple of implements that may help in getting the tarp ridge a little tighter whether you are using a continuous ridgeline or tarp tie-outs.
    We must, indeed, all hang together, or assuredly we shall all hang separately. - Ben Franklin
    (known as a win-win on this forum)

  6. #16
    Senior Member Detail Man's Avatar
    Join Date
    Aug 2010
    Location
    Knoxville, TN
    Hammock
    DIY or Bonefire Whisper
    Tarp
    DIY Silpoly
    Insulation
    Incubator, Burrow
    Suspension
    Bonefire Deluxe
    Posts
    889
    Images
    5
    The last pic looks like your tarp is tied off to the same biner as the hammock. Try rigging the tarp seperately from the hammock and see if that helps. A continuous ridgeline (a single cord) for the tarp should help as well. Put the tarp over the ridgeline so the tarp is supported along its length.

    You could also try just pitching the tarp over your ridgepole on your stand, and tying off to the ends of that pole.

  7. #17
    Member JakobW's Avatar
    Join Date
    Sep 2012
    Location
    Burlington County, NJ
    Hammock
    DIY Ripstop
    Tarp
    Kelty Noah 12
    Insulation
    HG 20* Incubator
    Suspension
    Whoopie Slings
    Posts
    91
    Thanks guys! I'll try some of these methods this week.

  8. #18
    Senior Member Rat's Avatar
    Join Date
    Oct 2006
    Location
    Bertram, Texas
    Hammock
    DIY 126 x 60 Tablecloth
    Tarp
    JRB 10 x 11
    Insulation
    New River/Owhyee
    Suspension
    Whoopie
    Posts
    1,389
    Images
    22
    First, non-cat cut tarps are more difficult to set up nice and taught. That's why there are so many cat cut tarps...
    Second, the asym tarps are even worse for keeping nice and taught as the force vector's don't exactly counter each other.
    Third, it needs to be suspended separately. Get rid of the mitten hooks and plastic ring. Tie directly to the tarp pull out and the trees, not the hammock suspension. Keep everything else off of the hammock suspension as well.

    When you tie to the trees it needs to be very tight.
    The guy-outs also need to be pretty tight and play with the angle to get the lines of force as nice as possible.

    The problem is that, eventually, it will stretch and get the slack back. You can use tensioners to counter this. This will also happen with a continuous ridge line set up. These methods will lessen the amount of slack but may not totally get rid of it; it's just a matter of the design.
    "I aim to misbehave." - Capt. Mal Reynolds
    Mind of a Rat Youtube Channel

  9. #19
    Senior Member Rat's Avatar
    Join Date
    Oct 2006
    Location
    Bertram, Texas
    Hammock
    DIY 126 x 60 Tablecloth
    Tarp
    JRB 10 x 11
    Insulation
    New River/Owhyee
    Suspension
    Whoopie
    Posts
    1,389
    Images
    22
    Here are a couple of images to illustate...

    My asym tarp over a DIY hammock; notice it is tied to the trees and guyed out pretty tight, yet it still has a little slack.


    Another shot with a ridge line that is a little short; notice much more slack...


    By comparison here is a cheap poly tarp that is square, not asym; see how nicely even this cheap tarp pitches?
    "I aim to misbehave." - Capt. Mal Reynolds
    Mind of a Rat Youtube Channel

  • + New Posts
  • Page 2 of 2 FirstFirst 12

    Similar Threads

    1. Soft Shackle "Quick release"/"ripcord" problem.
      By callook66 in forum Suspension Systems, Ridgelines, & Bug Nets
      Replies: 15
      Last Post: 01-22-2016, 07:23
    2. Replies: 8
      Last Post: 10-28-2014, 16:53
    3. My "Blackcat" tarp with "Dutch Rings"
      By Shotgunred in forum Do-It-Yourself (DIY)
      Replies: 26
      Last Post: 08-15-2011, 19:01
    4. Tarp "misting", "leakage", condensation etc.
      By Jsaults in forum Weather Protection
      Replies: 16
      Last Post: 06-21-2011, 12:45
    5. Replies: 2
      Last Post: 10-13-2010, 22:48

    Bookmarks

    Posting Permissions

    • You may not post new threads
    • You may not post replies
    • You may not post attachments
    • You may not edit your posts
    •