Hi everyone,
I am getting ready to finish my DIY top quilt, and have run into a snag. The baffles on the inside are 6" and on the outside, are 6.5. Is there a way to roll hem the edge neatly?
I need to do a fairly wide hem so that I can attach the omni tape for the footbox. The baffles run short ways.
Best i can figure is i need a small dart on each baffle chamber, but wanted to see if there is a better way.
I remember having this same issue with my underquilt, but since it was on the ends that were being cinched, I didn't care too much and just scrunched it as needed.
Thanks!!!
Bookmarks