Page 1 of 3 123 LastLast
Results 1 to 10 of 30
  1. #1
    Senior Member Heber's Avatar
    Join Date
    Mar 2008
    Location
    State College, PA
    Hammock
    DIY Bridge
    Tarp
    Zparks Cuben
    Insulation
    DIY Synthetic UQ
    Suspension
    marlin/whoopie
    Posts
    154

    Which should be thicker, UQ or top quilt?

    So I recently made an underquilt for my DIY bridge. No pictures (I know, I know, broke a cardinal rule) but it's not much to look at. It's rectangular (48" by 60") and uses 5osy Climashield from thru-hiker for insulation. For a top quilt you'd call that a 20 degree quilt.

    So last night I gave it a try. It was 25 degrees and I had a 20 degree down quilt on top and the 20 degreee climashield underquilt underneath. Definite cold butt syndrome (and shoulder when I slept on my side). Brr. The top insulation was plenty warm (slipped off my socks in fact during the night because I was getting too warm). I ended up putting my Ridgerest between the two layers of my bridge hammock and then I was fine of course.

    Now this isn't what I was expecting. I thought a 20 degree quilt above and a 20 degree quilt below would be fine. Instead I felt like I was fine on top but needed more underneath. Now there are several possibilities here.

    1. The climashield underquilt is not as warm as the down top quilt.

    2. Air leakage between the hammock and the underquilt. Certainly possible. I used clothespins to try to hold the quilt to the sides of the hammock but I'm sure it wasn't perfect.

    3. You just need more insulation under you than over you.

    Can someone with underquilt experience chime in? I've been a pad user so far so this was my first hang with an underquilt.
    Last edited by Heber; 01-12-2009 at 16:01.

  2. #2
    Senior Member Cannibal's Avatar
    Join Date
    May 2007
    Location
    Denver, CO
    Hammock
    Warbonnet ON!
    Tarp
    SuperFly or MacCat
    Insulation
    Yetis & Mambas
    Suspension
    Webbing and rings
    Posts
    13,919
    Images
    136
    The Climashield should be fine; how many layers were you using? I use a synthetic UQ made with Climashield and use, almost exclusively, top quilts made of down. Other than weight, the two seem pretty comparable...to me.

    I (well, my girlfriend) have only one night's experience in a bridge, but that night wasn't a good one insulation wise. I'm sure there are tricks to be learned with them, but my girl wasn't warm that night. She now says that it was because of the cold air coming in the ends, but that doesn't make sense if you say you were fine on top. Could it be that there are gaps between the hammock and the quilt on the sides of the hammock or on the bottom (drooping)?

    I do think the underside is more critical than the top. In my case (I know I'm weird), the only top quilt I have that is lighter than my UQ is my summer quilt; my backside seems to have it's own heater.
    Trust nobody!

  3. #3
    Senior Member Heber's Avatar
    Join Date
    Mar 2008
    Location
    State College, PA
    Hammock
    DIY Bridge
    Tarp
    Zparks Cuben
    Insulation
    DIY Synthetic UQ
    Suspension
    marlin/whoopie
    Posts
    154
    I was using 1 layer of 5 osy climashield.

    There could be a gap between the hammock and the quilt but not very major (from a visual inspection). Since the UQ is rectangular but the bridge is not rectuangular it's possible that the quilt sags on the bottom. But wouldn't that just be extra trapped air that should keep you warm?

  4. #4
    Senior Member Cannibal's Avatar
    Join Date
    May 2007
    Location
    Denver, CO
    Hammock
    Warbonnet ON!
    Tarp
    SuperFly or MacCat
    Insulation
    Yetis & Mambas
    Suspension
    Webbing and rings
    Posts
    13,919
    Images
    136
    Noooooo, air bubbles = bad. It's a fine line between snug and too loose or too tight. Once you get it right, try to not mess with your settings. Insulation works by trapping air, but we are talking microclimates, not pockets.

    OK, 1 layer isn't going to do much for you. My synthetic UQ has 4 layers (3 removable). I took it down to one layer for a few weeks in the summer and wished that I hadn't. If you can, add a layer or two and I think you'll notice a big difference, especially at 20F.
    Trust nobody!

  5. #5
    Senior Member
    Join Date
    Sep 2007
    Location
    Georgia
    Posts
    1,557
    Quote Originally Posted by Heber View Post
    I was using 1 layer of 5 osy climashield.

    There could be a gap between the hammock and the quilt but not very major (from a visual inspection). Since the UQ is rectangular but the bridge is not rectuangular it's possible that the quilt sags on the bottom. But wouldn't that just be extra trapped air that should keep you warm?
    I know Thruhiker claims 20 degree rating for one layer of 5 ounce climashield, I'd say freezing would be more realistic.

  6. #6
    cannibal basically had twice, not 4 times what you have, his 4 layers are only 2.5 ea.

    yeah, 5.0 to 20 deg seems optimistic. anybody have a single layer 5.0 cs tq?

  7. #7
    Senior Member Cannibal's Avatar
    Join Date
    May 2007
    Location
    Denver, CO
    Hammock
    Warbonnet ON!
    Tarp
    SuperFly or MacCat
    Insulation
    Yetis & Mambas
    Suspension
    Webbing and rings
    Posts
    13,919
    Images
    136
    Quote Originally Posted by warbonnetguy View Post
    cannibal basically had twice, not 4 times what you have, his 4 layers are only 2.5 ea.
    Well there ya go. He should know, he made it!
    Trust nobody!

  8. #8
    Senior Member
    Join Date
    Jan 2008
    Location
    Columbia, SC
    Posts
    633
    Images
    11
    Quote Originally Posted by warbonnetguy View Post
    yeah, 5.0 to 20 deg seems optimistic. anybody have a single layer 5.0 cs tq?
    I do, and have used it in the low 20s comfortably.

  9. #9
    well, maybe it's not that optimistic then. probably for an uq though.

  10. #10
    Senior Member
    Join Date
    Jan 2008
    Location
    Columbia, SC
    Posts
    633
    Images
    11
    Quote Originally Posted by warbonnetguy View Post
    well, maybe it's not that optimistic then. probably for an uq though.
    I think several people here have reported the 5osy XP working down to 20 as a top quilt, myself included. I do not recall a post about similar temperatures as an underquilt.

    I asked the same question (with a poll) Heber is asking a while ago and did not get a clear answer. I know I need more insulation under the hammock than up top, but cannot really quantify it very well.

Similar Threads

  1. Replies: 3
    Last Post: 07-02-2014, 13:09
  2. Replies: 27
    Last Post: 07-02-2014, 11:17
  3. DL hammock - thicker material, inside or out?
    By cardo in forum General Hammock Talk
    Replies: 2
    Last Post: 06-23-2013, 15:58
  4. Replies: 8
    Last Post: 08-14-2012, 10:09
  5. JRB's new, thicker "No Sniveller"
    By slowhike in forum General Hammock Talk
    Replies: 6
    Last Post: 09-24-2007, 14:27

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •