So I thought about it, and here's what I've come up with. I scaled the middle piece so that it should fit the entire way along the side and leave a quarter inch at top and bottom for the cord through the channel to come out.
What do you think? Any changes you think I should make?
Whoops, just noticed that the little bit at the end is supposed to get sewn into the channeling down there. That simplifies things a bit (one less bit of sewing ).
So, on my diagram distance F would increase by 0.25".
Last edited by Tijereyes; 03-06-2013 at 17:03.
Reason: Clicked "submit" too soon.