Ok, I'm confused. There are two sets of clips per side on my UQ. One set of clips is connected to shock cord which travels the full length of the UQ. I understand what this is for and I hook it to an S-biner which hooks to the suspension line. The second set of clips is attached to shock cord which clips to small tie-outs on the end of the UQ. This second set of clips I've taken off the UQ and it seems to work fine. So, what is the purpose of this second set of clips?
Is it so that once you set it up, the UQ doesn't slide around? If so, I may put it back on.
Bookmarks