I dislike using a prusik knot in amsteal and really the same goes for the Klemheist knot.
I find they either slip (slowly) or if I add additional wraps, they are almost impossible to slide them where I want them.
I'm trying to figure out what hardware will simplify what I want to be able to do with my tarp.
I have full length ridge line (Lash-It) with a Dutch Hook on one end and a Tarp Wasp on the other end.
I want to be able to secure the ridge line in place and then slide the tarp back and forth along the ridge line till I have it where I want it and lock it in place.
Tarp Keys, Tarp Crosses, Stingers, Wasps and Flyz are all designed to help with attaching to the tree. Really they are all just different versions of a Figure 9. I'm not aware of a way to use any of them that will do what I want.
I do have some Loop Aliens I haven't done a whole lot with but in order to use them, the ridge line would need to be slack enough I could pull a bite through one of the holes on the the LA.
I suppose what I need is almost a triglide or some mini descender rings.
Alternately I'd be happy with a clever splice like perhaps a short section of amsteel on each end of the tarp which the ridge line runs through so its almost like a mini-UCR.
I have a few thoughts on what might work, but before I reinvent the wheel, I wanted to double check and make sure I'm not overlooking an obvious method or product.
Ideas?
Bookmarks