So far I have been good with making continuous loops and whoopies using TheBrewGuy's videos. Tonight I was trying to make a FRL for my 11' hammock. I followed what I thought was step by step measurements but came out 6.5" too long. He made his for a Nano so I adjusted my measurements accordingly or so I thought. I cut my length of dynaglide to 130". At the start of the tip I measured @ 4" then to 8". Went to the opposite end and back measured from 130" to 126" then to 122". So from 8" to 122" should be 110" but its 114". I drew this out and followed what I thought was right. I didnt catch the 114" b/c I was sure this was correct. I guess I missed something along the line. Can you see where I messed up? Sorry if its obvious, ...new to this DIY stuff. Man am I honked off!!! Thanks for any help.
I was able to undo one of the loops to make it look like what it did when I started. Is it just that simple to cut off 6.5"? Not going any further until I hear more. Thanks again!
Bookmarks