Originally Posted by
TxAggie
As others mentioned, only the side pullouts need seam sealant. Here is how they recommend on Warbonnet's site:
"Seam sealing:
All our tarps incorporate low stretch polyester edge binding on the Ridgeseam, this means the ridge does not need any seam sealer, however if your tarp has panel pulls (SF, MJ, CB, GT) then you will want to seal the 4 panel pulls. You’ll want a suitable silicone (like GE Silicone II from the hardware store). Set up the tarp where you can leave it pitched for about 8 hours or so. Apply the thinnest possible layer of silicone (your finger works well) to the stitches (to the stitches only) on the underside of each panel pull (underside of tarp only), and leave the tarp setup till dry (4-12 hours depending on temperature)."
Bookmarks