2x2's bought - check
Paracord for lashing - check
Top rails bought - check
Going try my hand at continuous loops tonight or tomorrow & hopefully get everything lashed together tomorrow.
2x2's bought - check
Paracord for lashing - check
Top rails bought - check
Going try my hand at continuous loops tonight or tomorrow & hopefully get everything lashed together tomorrow.
Let's see, the 12' long ridge Poll holds the center of the tri pods at 10' apart at there center when lashed together. The tarp at 11' from (D ring to D ring) goes over this sable structure, It's a hex tarp no other parts in the way. The 6" slips in between the three uprights on top of the poll and lashed. My hammock has a 8' distance from it's ridge line points, then the whoopee slings hang from the ends of the ridge poll pulling the weight down the legs and not pulling the tri pods together at the top.
Little people had a lower swing height than the adults. The points at the bottom of the landscape polls dig in and stay put yet can be Easley moved.
Hope this helps.
Thanks ONT
I think I'm going to cut them like hppyfngy, 2 x 5', 1 x 6' & 1 x 4'. I can try 14' and go from there.
That way my tarp ends aren't on the tripods at all.
I would think The length of the ridge poll should be long enough for the tarp to lay flat on the poll and not over the tri pods (could poke a hole in the tarp). It just needs to be stouter the longer it gets, to hold the weight and compression over a longer span. IMHO. Just trying to help.
ONT
Bleh! I failed. Lashings didn't hold and I was slowly lowered to the ground.
Also, my continuous loops were too short.
When I get time I'll see if I can tighten everything up or grab some hardware and convert it to a TDS.
Bookmarks