Results 1 to 4 of 4

Thread: material width

  1. #1
    New Member Maguwa's Avatar
    Join Date
    Nov 2012
    Location
    Tokyo, Japan
    Posts
    8

    material width

    Hello all,
    A quick question, I've tried searching the forums, as I'm sure it has been covered, but couldn't find the answer.

    I'm getting ready to start my first DIY hammock, planning on a WarBird type. My question is regarding the bottom sheet width. I have been able to find some good material in my area (Tokyo), but the width is only 122cm(48"). The plans I have found call for ~60". Is it possible to use a seam on the bottom piece to achieve the desired width?

    Would the seam have any negative effects, strength, comfort? Also, if it is possibe to use a seam, where should it go? down the middle? down the left/right side? two seams?

    Thank you in advance! This forum is tops!

  2. #2
    Senior Member JohnSawyer's Avatar
    Join Date
    Sep 2009
    Location
    San Diego, CA
    Hammock
    WB RidgeRunner
    Tarp
    8x10 DIY (speer)
    Insulation
    KAQ Lost River
    Suspension
    Straps
    Posts
    4,696
    Images
    108
    Many commercial hammocks have seams down them.... From a comfort perspective, definitely go with 3 pieces, laying on a seam isn't very comfortable.

    Depending on your height, 48" might not be too bad... Since the warbird design has an extra piece of fabric on the other side of the zipper, it might be ok.... you'll have to try it to see.

    I would take the hammock body and just whip the end and lay in it... see how much room you have . . .

    John
    "Do or do not, there is no try." -- Yoda


  3. #3
    Ramblinrev's Avatar
    Join Date
    Apr 2008
    Location
    Milton, PA
    Hammock
    Hennessey Explorer Ultralight
    Tarp
    Hennessey Hex
    Insulation
    HH Super Shelter
    Suspension
    ring buckle
    Posts
    7,298
    Images
    101
    A single seam down the middle of the hammock bed would be problematic. Aside from the discomfort of laying full on a seam, it would alter the stretch characteristics of the bed. Add panels to each side to get get the width you want. Remember there is some loss due to the hem/seam allowances so make sure you add that onto your pattern calculations. I recommend a flat-felled seam, or its cousin, the folded down french seam. Either is a good strong seam and will take the stress placed on the seams.
    I may be slow... But I sure am gimpy.

    "Bless you child, when you set out to thread a needle don't hold the thread still and fetch the needle up to it; hold the needle still and poke the thread at it; that's the way a woman most always does, but a man always does t'other way."
    Mrs. Loftus to Huck Finn

    We Don't Sew... We Make Gear! video series

    Important thread injector guidelines especially for Newbies

    Bobbin Tension - A Personal Viewpoint

  4. #4
    New Member Maguwa's Avatar
    Join Date
    Nov 2012
    Location
    Tokyo, Japan
    Posts
    8
    Thank you both for your insight/guidance! Ramblinrev, I now know what those seams are thanks to your video tutorials.
    I hope to get started on this project soon. This advice gets me one step closer!
    Cheers!

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •